Good results of the mixer manufacturer equipment

However, since the environmentally friendly small concrete mixing plant has been used, the situation has suddenly become more and more cheerful. Small concrete mixing plants have many advantages. The obvious advantages are low investment, fast profit, and because they are new equipment, they are very environmentally friendly. We don’t have to worry about a lot. Problems such as low noise, low dust, sewage treatment in place, higher utilization of concrete, etc.

The cylinder batching type utilizes the material gravity to flow down the floor, so the batching speed is fast, the mixer manufacturer equipment is suitable for medium and large mixing stations, and the concrete mixing station (floor) above HZS50 is used. 1. Learn from the old users of the forced concrete mixer, ask about the daily output of the forced concrete mixer, the failure rate, whether the after-sales service is better, and where the price of your forced concrete mixer is purchased; the mixer equipment cable Be protected and prevent damage. The mixer should be leveled.

Do not stand under the mixer funnel to prevent injury when the funnel falls into the water. When temporarily stopping the rail, start the mixer regularly (every twenty minutes) to prevent the crucible from solidifying or pour out the inside of the drum and rinse the drum with water. The concrete model and the equipment of the mixer are mainly based on the material and transportation system. The construction of the control system and the accessories are related to the pen. The working principle is mainly based on the many concrete mixing plant equipment in Chengdu. The structure of production and mixing and stirring is mostly the upper material storage hopper, the heightening plate is set for increasing the storage capacity, and the lower part is the measuring bucket: the whole measuring bucket can be equipped under the batching door, and the concrete batching equipment manufacturers make the materials successively Equipped with the same measuring hopper (accumulated metering), a separate measuring hopper (each material) can be set under each batching door, and the finished metering material is sent to the next step by the bottom belt conveyor.

The secondary maintenance cycle of the concrete mixer is generally 700~1500h working hours. In the second-level maintenance, in addition to stopping the first-level maintenance work, the reducer, motor and open gear must be dismantled, in addition to checking the machine and discharging. Dominating mechanism, cleaning the walking wheel and steering mechanism. 1. When disassembling the reducer, the gears, shafts, shafts and oil passages must be cleaned. The wear level of the halogen profile should be checked. The new gear oil is added. 2. When removing the motor, clean the dust on the stator winding, clean the bearing and add new smooth grease, check and adjust the gap between the stator and the rotor. In the construction of rural areas, the equipment of the mixer manufacturers will produce a lot of pollution, such as dust pollution, noise pollution, sewage discharge, etc., especially when some mixing stations are built by the river, the equipment of the mixer manufacturers is not only polluted. River water, farmland cultivation, the environment we live in, and so on.

In the face of such a phenomenon, the general mixing station will produce such an effect. After the concrete and the mixing equipment are made and the superiority is determined, the mixing of the powder and the additives can be carried out, and the quality is generous. Aesthetics and treatment will make the structure and strength of the whole agitation more in line with the needs of the public. In the mixing performance of concrete, it is very important to maintain the stirring speed and the agitation of the hardness. It is very important in the concrete mixing equipment. Mainly due to the mixing aids and storage on the material weighing system and material handling system.