Method for extending the service life of mixer equipment manufacturers

The material selection of the mixer manufacturer is to choose different materials according to different usage environments. Generally, a weak acid is used, and the non-corrosive normal material is stirred to select stainless steel. Carbon steel epoxy should be selected if there is strong acid material agitation. If there is a higher requirement for the service life of the agitator, carbon steel rubber is recommended.

Normally, more need to maintain the mixer manufacturer, which may extend the use time of the mixer parts. If it is not used properly, it may cause damage to the equipment too early, so it is necessary to maintain it frequently. Under normal circumstances, the impeller type agitation is adopted, and the suction port is arranged on the upper side, and the suction port is appropriately opened through the adjustment plate. This makes it possible for the mixer to form a negative pressure in the mixing chamber during operation, and it can be discharged into the screen in time by stirring, which is also very advantageous.

If the opening of the adjusting plate is too small, the air intake is not too large, the negative pressure in the stirring chamber is small, the stirring material will be discharged poorly, and the stirring material is too pulverized, and the heat in the stirring chamber cannot be discharged in time, which will result in the mixer. The interior is too hot. If you work in an overloaded state for a long time, there will be a situation in which the mixer has a fever or burns the motor. The correct way is to actively correct the machine when it is working, especially at 90% of the rated load, and then use the correct method and voltage.

Any mixer that uses a blender wants to buy the blender that works, and does not require frequent repairs and replacement parts. In other words, if you want to extend the life of the mixer during use, you need to master some methods to ensure that the life of the mixer can be extended.